Easy to work with
Panels are easy to find, cut and install.
With plumbing and wiring done, the walls get closed in. Drywall is an easy, effective alternative to traditional plaster.
8 to 16 inches
48 to 54 inches
Beyond the standard panel, there is a type for most jobs.
Special-use panels
Newer options
It is quick to work with and does a lot for the finished wall.
Panels are easy to find, cut and install.
Flexible and resists sagging. Properly reinforced, it resists cracking too.
Paint and other finishes go on well.
Reduces excess moisture during construction.
Gypsum doesn't burn, which adds a layer of fire safety.
Helps keep noise between rooms down.
Insist on good material and neat, precise fitting. Then measure the framed walls to work out what you need.
The seam also lands at a comfortable height for taping, except with 54-inch panels.
Use the full range of panel sizes to cut waste and seams.
Before you hang
Long panels need two people. They tape and finish better, but they are heavy. Plan for a second pair of hands to lift and hang them.
Hover or tap any tool for more detail.
Measure and mark
Cut
Lift and reach
Fasten
Extra hold. Add drywall adhesive for more holding power.
Reach out to the JSW Cement team before you start.
Newer products make for flatter seams and a stronger hold.
In colder climates, ceilings need a poly vapour or air barrier. Resilient channel gives a framing layout that stops the plastic being punctured.
They pull butt edges inward into a recess that looks like a tapered seam. Fasteners can sit further from the edge, so fewer screws pop.
Turns a butt joint into a tapered one. It is easy to finish, flat and almost invisible in bright light. Keep it away from the plates so the sheet can bend to match.
Polyurethane spray foam beats caulk-gun adhesive. It lays an even bead and holds harder, even on steel.
They have replaced drywall saws for most cutting because they are faster.
Taping used to mean a trowel, taping knives, paper tape and a pail of joint compound. Newer hand and automatic tools have largely taken over.
Hand taping tools
For seams, corners and covering fasteners. Narrow 1:6-inch knives suit tight spots. Wider knives have a metal tip for resetting nail heads. Look for a stiff blade with a slight curve when viewed head-on.
A hawk holds compound while you work with the knife. A pan suits thinner compound and doubles as a mixing tub.
Curved or bevelled trowels give better control over how much compound comes off than flat ones.
Have a metal strip on the back for strength. Used to bed tape on seams when working with automatic tools.
They are expensive, but you can rent them instead of buying.
Two main types, each suited to a different kind of job.
One of the most popular. Mostly vinyl-based, and needs proper drying time between coats.
Powder only. It hardens before it fully dries.
Next up: the components of your roof.